Fujitsu PRIMERGY RX2540 M4, Upgrade And Maintenance Manual, Page: 565 / 639

RX2540 M4
Upgrade and Maintenance Manual 565
Appendix A
Indication of LAN connection supporting Energy Efficient Ethernet
(EEE mode)
To configure the EEE mode, it is necessary that the on board LAN or an add in
LAN card supports this mode and the connected switch supports this mode as
well.
I
Note on the onboard LAN controller
The system board is equipped with a Gigabit Ethernet Controller that
supports transfer rates of 10 Mbit/s, 100 Mbit/s and 1 Gbit/s.
The separate management LAN connector is used as a management
interface (iRMC S4) and is prepared for operation with the Remote
Management. Optionally LAN connector 1 can also be used for iRMC S4
server management.
Pos. Indicator Status Description
1 LAN
link/transfer
indicator short flashing
green 3x,
then off A LAN connection has been established
(1 Gbit or 100 Mbit) and EEE mode is
active
2 LAN speed
indicator short flashing
yellow 1x,
then
2 seconds off
green off
Data traffic at a transfer rate of 1 Gbit/s.
short flashing
green 1x,
then
2 seconds off
yellow off
Data traffic at a transfer rate of
100 Mbit/s
Table 3: LAN indicators if EEE mode is active