Fujitsu PRIMERGY RX1330 M1, Upgrade And Maintenance Manual

Page: 84 / 312

84 Upgrade and Maintenance Manual
RX1330 M1
Basic software procedures
Ê
For the changes to take effect, you need to reboot the network by entering
the following command:
# service network restart
I
If the system board or network controller offers multiple LAN ports, it is
necessary to update the remaining
ifcfg-eth<x> definition files
accordingly.
Ê
Update the NIC configuration file to reflect the new card sequence and MAC
address.
5.2.13 Resuming BitLocker functionality
If BitLocker Drive Encryption has been suspended for maintenance purposes
(see section
"Suspending BitLocker functionality" on page 63 ), it has to be re-
enabled to complete the service task.
I
If BitLocker Drive Encryption has been suspended prior to replacing
components you won't be asked for a recovery key when rebooting the
server after the maintenance task. However, if BitLocker functionality has
not been suspended, Windows will enter recovery mode and ask you to
input recovery key for further booting.
Ê
In this case, ask the system administrator to enter the recovery key in
order to boot the operating system.
Ê
Ask the system administrator to enable the previously suspended BitLocker-
protection on the system volume, using the
BitLocker Drive Encryption control
panel item:
For Windows Server 2008:
Ê
Open BitLocker Drive Encryption by clicking the
Start
button, clicking
Control Panel
, clicking
Security
, and then clicking
BitLocker Drive
Encryption
.
Ê
Select the system volume, and click
Turn On BitLocker
.
For Windows Server 2008 R2 and above:
Ê
Open BitLocker Drive Encryption by clicking the Start button, clicking
Control Panel , clicking System and Security , and then clicking BitLocker
Drive Encryption .
Ê
Select the system volume, and click Resume Protection .