26
U41271-J-Z156-2-76
Installing the Rack Model in the Rack
Installation
Ê
Mount the support bracket at the appropriate height on the left rear support
upright as described in the technical manual of the PRIMECENTER Rack.
To fasten the telescopic rails, no flange nuts are necessary since the assembly
brackets are equipped with threaded holes. For adjustment in each case two
mounting springs must be pre-mounted at the support uprights and the support
bracket (see figure 8 on page 29):
Ê
Place the mounting springs (1) in the holes of the support uprights and/or of
the support bracket at the marked attachment points.
Figure 6: Mounting the telescopic rails in the PRIMECENTER Rack
Ê
Using the supplied Allen key (No. 5) secure the end of the telescopic rails
with the corresponding assembly brackets with two screws M4 each (1 and
2) in the rack at the support uprights and/or at the support bracket.
Note with the fact that two mounting springs each are used in the appro-
priate openings of the support uprights and/or the support bracket (see
figure 8 on page 29).
Ê
Adjust if necessary the length of the telescopic rails by using the oblong
holes of the assembly brackets HL and HR.
