U41271-J-Z156-2-76
25
Installation
Installing the Rack Model in the Rack
Figure 5: Prepare the telescopic rails
Ê
Fasten the delivered assembly bracket VL on the front end of the left
telescopic rail (1) with two screws M5x8 (2) as shown in figure 5.
Ê
Fasten the delivered assembly bracket HL on the rear end of the left
telescopic rail (3) with two screws M5x8 (4) and two hexagonal flange nuts
M5 as shown in figure 5.
Ê
Repeat the procedure also for the right telescopic rail and the corresponding
assembly brackets VR and HR.
For mounting the left telescopic rail in the PRIMECENTER Rack, the delivered
support bracket must first be mounted on the rear left support upright. The
bracket must be mounted level with the lower edge of the device.
Ê
Refer to the assembly instructions in the Technical Manual for the PRIME-
CENTER Rack (see also “Related publications” on page 85).
I
For better orientation the height units are marked on the support
uprights.
