34
Operating Manual
Econel
100
Switching the Server ON and OFF
Preparation for Use and Operation
5.2
Switching the Server ON and OFF
V
CAUTION!
If after switching ON the server there is nothing but flickering stripes on
the screen, switch the server OFF immediately (see
chapter “Trouble-
shooting and Tips” on page 41
).
The power button does not separate the server from the line voltage. To
disconnect the device completely from the mains, you must switch off the
master switch (if present on the back of the device) (see
figure 5 on
page 33
) and remove the plug.
Switching the server ON
The power-on indicator (position 2 in
figure 4 on page 31
) lights orange
(standby mode) when the server is connected to the network and the master
switch (if present) is switched on (see
figure 5 on page 33
).
–
First system installation:
Ê
Press the ON/OFF button (position 3 in
figure 4 on page 31
).
Power-on indicator lights green (position 2 in
figure 4 on page 31
).
Ê
Insert the
ServerStart
-CD and/or an installation disk in the corresponding
drive.
Ê
Follow the on-screen instructions (see also
section “Configuration with
ServerStart” on page 36
or
section “Configuration without ServerStart”
on page 37
).
–
System already installed:
Ê
Press the ON/OFF button (position 3 in
figure 4 on page 31
).
The server is switched on, performs a system test and boots the
operating system.
Switch off server (ACPI compatible operating systems, e. g.
Windows 2000, Linux)
The power-on indicator lights green (position 2 in
figure 4 on page 31
).
Ê
Terminate the operating system correctly.
The server is switched off automatically and goes into standby mode. The
power-on indicator lights orange.
