C141-E034-02EN
5 - 79
NAME
MODE 0
(in ns)
MODE 1
(in ns)
MODE 2
(in ns)
COMMENT
MIN
MAX
MIN
MAX
MIN
MAX
t
IORDYZ
20
20
20
Pull-up time before allowing IORDY to be
released
t
ZIORDY
0
0
0
Minimum time device shall wait before
driving IORDY
t
ACK
20
20
20
Setup and hold times for DMACK- (before
assertion or negation)
t
SS
50
50
50
Time from STROBE edge to negation of
DMARQ or assertion of STOP (when
sender terminates a burst)
Notes:
1) t
UI
, t
MLI
and t
LI
indicate sender -to-recipient or recipient-to-sender interlocks, that is, one agent (either
sender or recipient) is waiting for the other agent to respond with a signal before proceeding. t
UI
is an
unlimited interlock, that has no maximum time value. t
MLI
is a limited time-out that has a defined
minimum. t
LI
is a limited time-out, that has a defined maximum.
2) All timing parameters are measured at the connector of the device to which the parameter applies. For
example, the sender shall stop generating STROBE edges t
RFS
after the negation of DMARDY-. Both
STROBE and DMARDY- timing measurements are taken at the connector of the sender.
3) All timing measurement switching points (low to high and high to low) are to be taken at 1.5 V.
Summary of Contents for MPA3017AT
