C141-E034-02EN
5 - 66
10) The device shall latch the host's CRC data from DD (15:0) on the negating edge of
DMACK-.
11) The device shall compare the CRC data received from the host with the results of its own
CRC calculation. If a miscompare error occurs during one or more Ultra DMA bursts for
any one command, at the end of the command the device shall report the first error that
occurred (see 5.5.5).
12) The device shall release DSTROBE within t
IORDYZ
after the host negates DMACK-.
13) The host shall not negate STOP no assert HDMARDY- until at least t
ACK
after negating
DMACK-.
14) The host shall not assert DIOR-, CS0-, CS1-, DA2, DA1, or DA0 until at least t
ACK
after
negating DMACK.
b) Host terminating an Ultra DMA data in burst
The following steps shall occur in the order they are listed unless otherwise specifically
allowed (see 5.6.4.6 and 5.6.4.2 for specific timing requirements):
1)
The host shall not initiate Ultra DMA burst termination until at least one data word of an
Ultra DMA burst has been transferred.
2)
The host shall initiate Ultra DMA burst termination by negating HDMARDY-. The host
shall continue to negate HDMARDY- until the Ultra DMA burst is terminated.
3)
The device shall stop generating DSTROBE edges within t
RFS
of the host negating
HDMARDY-.
4)
If the host negates HDMARDY- within t
SR
after the device has generated a DSTROBE
edge, then the host shall be prepared to receive zero or one additional data words. If the
host negates HDMARDY- greater than t
SR
after the device has generated a DSTROBE
edge, then the host shall be prepared to receive zero, one or two additional data words.
The additional data words are a result of cable round trip delay and t
RFS
timing for the
device.
5)
The host shall assert STOP no sooner than t
RP
after negating HDMARDY-. The host
shall not negate STOP again until after the Ultra DMA burst is terminated.
6)
The device shall negate DMARQ within t
LI
after the host has asserted STOP. The device
shall not assert DMARQ again until after the Ultra DMA burst is terminated.
7)
If DSTROBE is negated, the device shall assert DSTROBE within t
LI
after the host has
asserted STOP. No data shall be transferred during this assertion. The host shall ignore
this transition on DSTROBE. DSTROBE shall remain asserted until the Ultra DMA
burst is terminated.
8)
The device shall release DD (15:0) no later than t
AZ
after negating DMARQ.
9)
The host shall drive DD (15:0) no sooner than t
ZAH
after the device has negated DMARQ.
For this step, the host may first drive DD (15:0) with the result of its CRC calculation (see
5.5.5).
Summary of Contents for MPA3017AT
