IP-HE950 Hardware User's Guide
Chapter 3 Operation Instructions
Copyright 2017 FUJITSU LIMITED
39
3.4
Special Use of the
CANCEL Key
Start the IP-HE950 by holding down the [CANCEL] key during the power-on operation.
When you hold down the key until the RDY LED begins blinking in orange, the IP-HE950
starts with the factory default values for the IP address and subnet mask (LAN1: IP address
10.0.0.1 and subnet mask 255.0.0.0; LAN2: IP address 192.168.255.253 and subnet mask
255.255.255.252).
Use this feature to initialize the unit settings from a control terminal (e.g., PC with a LAN
interface).
(Note 1) To operate the IP-HE950 with the default IP address, connect it to a control
terminal and configure settings with it disconnected from your network.
After configuring settings appropriate to your network, connect it to the network. If
connected as is with the factory default settings, the unit may cause an
unexpected problem to occur in the network.
After starting the IP-HE950 while holding down the [CANCEL] key, set the
following IP addresses and subnet masks for the control terminal to be connected:
- LAN1 IP address: 10.xxx.xxx.xxx
(xxx is any number from 0 to 255, except for 10.0.0.0, 10.0.0.1, 10.0.0.2, and
10.255.255.255.)
- LAN1 subnet mask: 255.0.0.0
- LAN2 IP address: 192.168.255.254
- LAN2 subnet mask: 255.255.255.252
3.4
