Fujitsu control 4 0812, User Manual

Page: 69 / 552

4.12 Using virtual media
2. To map a physical drive as a virtual media drive, complete the following
steps:
a. In the Virtual Media window, select the Mapped check box next to the
drive or drives you want to map.
b. If you want to limit the mapped drive to read-only access, select the
Read Only check box next to the drive prior to mapping the drive. If the
virtual media session settings were previously configured so that all
mapped drives must be read-only, this check box is already enabled
and cannot be changed.
You might want to select the Read Only check box if the
session settings enabled read and write access, but you want
to limit the access of a particular drive to read-only.
3. To add and map an ISO or diskette image as a virtual media drive, complete
the following steps:
a. In the Virtual Media window, click Add Image .
b. The Common File Chooser window opens, with the directory containing
disk image files (ending in .iso or .img) visible. Select an ISO or diskette
image file and click Open .
c. The file header is checked to make sure it is correct. If it is, the Common
File Chooser window closes and the chosen image file opens in the
Virtual Media window, where it can be mapped by selecting the Mapped
check box.
d. Repeat steps a through c for any additional ISO or diskette images you
want to add. You can add any number of image files (up to the limits
imposed by memory), but you can only have one virtual DVD-ROM or
virtual mass storage mapped concurrently.
If you attempt to map too many drives (one DVD and one mass storage
device) or too many drives of a particular type (more than one DVD or
mass storage device), a message is displayed. If you still want to map a
new drive, you must first unmap an existing mapped drive, then map the
new drive. After a physical drive or image is mapped, it can be used on
the target device.
To unmap a virtual media drive:
Eject the mapped drive from the target device. Clear the Mapped check box.
590-1059-640A
63