FujiFilm Sonosite PX System, Service Manual

Page: 55 / 110

Chapter 6: Replacement Procedures 47
Chapter 6: Replacement Procedures
Caution:
Always use correct ESD procedures. ESD damage is cumulative and may not be noticeable at first. Initial
ESD symptoms may be slightly degraded performance or image quality.
Caution:
All fasteners should be torqued to 5.5-inch pounds except where noted. Two ranges of torque screwdrivers
will be required as torque requirements range from 2-inch pounds to 24-inch pounds. Generally the torque
screwdrivers ranges are 1.0-10.0 inch pounds (0.23-1.1 Newton meter) and 10.0-25.0 inch pounds
(1.1-2.8 Newton meter)
Note: When repairs are performed, the system should be fully tested in accordance with Chapter 8.
Required Tools
• Torx bits: T6, T8, T10,T20 and T30
• Torque screwdriver, 1.0-10.0 inch pounds (0.23-1.1 Newton meter)
• Torque screwdriver, 10.0-25.0 inch pounds (1.1-2.8 Newton meter)
• Small flat head screwdriver
• #2 Phillips screwdriver
• Anti-Static mat
• Wrist grounding strap
Remove Batteries
Remove the batteries and disconnect DC power before servicing the Sonosite PX. Any action taken in this
chapter assumes this as the first step.
1 Place the system on its top so the serial number label is facing up.
2 Remove the six Phillips screws from the battery cover per Figure 6.1 on page 47 .
3 Remove the battery cover.
4 Disconnect battery connectors.
5 Remove batteries.
Figure 6.1 Battery Removal
Remove 6 Phillips screws and remove
Battery Cover
Disconnect Batteries and
remove from enclosure