54
Chapter 6:
Replacement Procedures
Figure 6.11 Display Hinge Tubes
Install Clinical Display
1
Install the left and right Hinge Tubes on new Clinical Display per
Figure 6.11 on page 54
.
2
Install the center Hinge Tube.
3
Carefully feed the Clinical Display cable through the Bottom Enclosure shown in
Figure 6.9 on page 53
.
4
Place the Clinical Display on top of Bottom Enclosure and line the hinges up with the screw holes per
Figure 6.10 on page 53
.
5
Install two screws in each hinge with a T20 bit and tighten to 5.5 inch pounds.
6
Connect the Clinical Display Cable to the Main PCBA, J3002 per
Figure 6.10 on page 53
.
7
Put Display Cable EMI Shield in place and secure the two screws with a T6 bit. Tighten to 2.0 inch
pounds.
8
Feed the Wireless Dongle USB Cable through the Rear Enclosure and snap Rear Enclosure in place
per
Figure 6.8 on page 52
.
9
Remove tape holding On/Off Button in place.
10 Connect the Wireless Dongle to the USB cable.
11 Install the Wireless Dongle onto the Rear Enclosure per
Figure 6.7 on page 51
.
12 Install the User Interface.
13 Install the Batteries.
Center Hinge Tube
Right Hinge Tube
Left Hinge Tube
Summary of Contents for Sonosite PX System
