FujiFilm FINEPIX 2600 ZOOM, Owner'S Manual

Page: 41 / 47

80 81
Warning Displayed Explanation Remedy
There is a strong likelihood of
camera shake because the
shutter speed is slow.
A protected frame was erased.
Outside the AE continuous range.
Protected files cannot be erased. Unprotect the
frame using the camera on which the
protection was first applied.
The shot can be taken, but the exposure will
not be correct.
Use flash photography. However, a tripod
should be used for some scenes and modes.
i The data could not be recorded
due to a SmartMedia error or a
connection error between the
SmartMedia and camera.
i The photographed image
cannot be recorded as it is too
large to fit in the available
space on the SmartMedia.
i Re-insert the SmartMedia or switch the
camera off and then on again.
i Use a new SmartMedia.
The frame number has reached
999–9999. Take the shots using a formatted SmartMedia.
The AF (auto focus) cannot work
effectively.
i If the image is too dark, take the picture at a
distance of around 1.5 m (4.9 ft.) from the
subject.
i Use AF lock to take the picture.
(Lit red) (Flashing red)
Warning Displays
e
The table below lists the warnings that are displayed on the LCD monitor
Warning Displayed Explanation Remedy
The camera battery is low on
charge.
There is no SmartMedia loaded, or the
SmartMedia loaded is a 5-volt card.
i The SmartMedia is not formatted.
i
The SmartMedia terminals are
soiled.
i Camera fault.
i
The SmartMedia terminals are
soiled.
i
The SmartMedia is damaged.
i The SmartMedia format is
incorrect.
i Camera fault.
The SmartMedia is fully recorded.
The SmartMedia is write-protected.
i An attempt was made to
playback a frame not recorded on
this camera.
i The SmartMedia terminals are
soiled.
i You attempted to play a movie
with a recording time longer than
20 seconds.
Replace or recharge the battery.
Load a SmartMedia (3.3-volt).
i Wipe the contact area on the SmartMedia with a
soft dry cloth. It may be necessary to format the
SmartMedia. If the error message is still
displayed, replace the SmartMedia.
i Contact your FUJIFILM dealer.
i
Wipe the contact area on the SmartMedia with a
soft dry cloth. It may be necessary to format the
SmartMedia. If the error message is still
displayed, replace the SmartMedia.
i Contact your FUJIFILM dealer.
Use a SmartMedia that is not write-protected.
i Images cannot be played back.
i Wipe the contact surface on the SmartMedia
thoroughly with a soft, dry cloth. In some cases,
you may have to format the SmartMedia.
i You cannot play back movies that are more than
20 seconds long.
Erase some images or use a SmartMedia that has
ample free space.