FujiFilm DRI-CHEM NX10N, Instruction Manual

Page: 59 / 102

8 Mode Settings and Functions
8-5
8
897N120152H FDC NX10N Instruction Manual 04.2022
8.3 Mode 1 - Turning on the Control Mode (a, b canceled) <Normal>
This mode is used for daily measurements of control fluids (FUJI DRI-CHEM CONTROL QN), which is used
for precision management, and for control surveys.
When the control mode is selected, the analyzer calculates the concentration with the correlation coefficients
for all tests reset to a=1 and b=0.
- Correlation coefficients for all test names (Mode 10 settings) ==> Resets to (a=1, b=0)
- Units (Mode 8 settings) ==> Resets to Unit (A)
On the printout for each measurement, the indication [Control mode] appears after the sample No.
NOTE:
The control mode will be canceled after turning the analyzer off and turn it back on.
MODE
START
(1) Enter into Mode 1.
/㩄㩧㩎㩥㨺㩣㩝㨺㩎㩨
㩆㩨㨹㩄㨽
㩀㨼㩆㩨㨸
Quits Mode
A beep sounds when saving data is complete.
Displayed about
two seconds
̪
Printed by the external printer
/%QPVTQNOQFG
5GV
4GUGV
/㩄㩧㩎㩥㨺㩣㩝㨺㩎㩨
㩆㩨㨹㩄㨽
㩀㨼㩆㩨㨸
/%QPVTQNOQFG
5GV
4GUGV
/%QPVTQNOQFG
5GV
/%QPVTQNOQFG
4GUGV
START
Select
MODE RERUN
(2) Select [Set] or [Reset] .
Select the control mode setting or resetting by
the scroll keys , then press the ENTER
key.
NOTE: The shaded part is a selected menu.
The analyzer displays the selection ( [Set] or [Reset] )
and quits the mode operation.
5 H D G \
,'
ڦ
&RQWURO
/RW1R 3!
(3) When the control mode is selected, [Control]
will be displayed on the display.
NOTE: If measurement is performed in the control
mode, the indication [Control] also appears in
the test result dialog. The reference interval is
not displayed.
,'
&RQWURO
ࠉ ࠉ
XJGO
/RW1R 3!