2 - 48
HITACHI PLC • 1
(HIDIC H series)
17
Available PLC
*
1 When using [EH-RS05] cable made by HITACHI, connect the cable of [Wiring Diagram 1] to the
D-sub 15 pins side of [EH-RS05] to communicate with POD.
*
2 When using [CNCOM-05] cable made by HITACHI, connect the cable of [Wiring Diagram 1] to
the D-sub 15 pins side of [CNCOM-05] to communicate with POD.
Communication Setting
The recommended communication parameter setting of both PLC and POD is as follows:
COMM-2H
If “Transmission control mode” is any other type except the above, specify “Transmission control
code” as below.
*
1
Cannot be connected to POD by multi-link connection.
CPU module
Peripheral port is only available with “pattern 1.”
Port
Transmission
Control Mode
RS-232C
RS-422
MODE7
MODE9
Protocol 2 w/ Port
Protocol 2 w/ Port
19200bps
Even
7 (ASCII)
Baud Rate
Parity
Transmission
Code
Data Length
Stop Bit
1
Sumcheck
Item
Setting of PLC
0
19200bps
Even
7
1
*
1
0 for both STATION 10 and 1
Comm. Parameter of POD
Provided (fixed)
Transmission
Control Mode
RS-232C
RS-422
MODE1
MODE2
MODE9
MODE2
Protocol 1 w/ Port
Protocol 1 w/o Port
Protocol 1 w/ Port
Protocol 2 w/o Port
Setting of PLC
*
1
Comm. Parameter of POD
PLC
Link Unit
Wiring Diagram
HIDIC H series CPU
RS-232C [Wiring Diagram 1]
RS-232C [Wiring Diagram 1]
RS-422 [Wiring Diagram 2]
COMM-2H
PERIPHERAL port
on a CPU module
Select PLC Type
HIDIC-H
*
1 [EH-RS05] cable made by HITACHI
+ RS-232C [Wiring Diagram 1]
EH150
PERIPHERAL 1
RS-232C [Wiring Diagram 1]
PERIPHERAL 2
*
2 [CNCOM-05] cable made by HITACHI
+ RS-232C [Wiring Diagram 1]
H-252C on a CPU module
17 HITACHI PLC
•
1
Summary of Contents for UG220H Series
Page 270: ...Appendix Ladder Transfer Function...
