45 SERIES GAS FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
3-5
2.
Press a product switch to initiate a cook
cycle.
a. The display will indicate the previ-
ously programmed cook time and be-
gin countdown.
b.
If shake time is programmed, the op-
erator will be notified of the need to
shake the product “X” seconds after
the cook cycle has begun (X = amount
of time programmed). An alarm will
sound, and the display will read
SH
####
,
where “#” will be the switch number.
If no shake time has been programmed,
sh
####
will not appear during the cook
cycle. The alarm is self-canceling.
c.
At the end of the cooking cycle, an
audible alarm will sound,
cooc
will
be displayed, and the associated prod-
uct switch indicator will flash. To
cancel the cook alarm, press the ap-
propriate switch.
d. At this time, the hold time will be dis-
played (if programmed greater than
zero), and the countdown will begin.
When the countdown reaches zero,
hD_
hD_
hD_
hD_
will be displayed and an alarm
will sound. The blank will be the
switch number. The hold alarm is can-
celed by pressing the Programming
switch
.
NOTE
: If the display is in
use, the hold time countdown will not
be displayed.
3.
To check the frypot temperature at any
time, press the Temperature Check switch
once. To check the setpoint, press the
switch twice. If you suspect the tempera-
ture probe is defective, check the tem-
perature of the frypot with a thermometer
or pyrometer to verify that the computer
readout is reasonably close to the meas-
ured reading.
4. During idle periods when the fryer is on
but not in use, “
- - - -
” should appear in
both displays. If not, check the actual
temperature and setpoint.
CAUTION
The electronic circuitry in your
computer can be affected adversely by
current fluctuations and electrical
storms. Should it fail to function or
program properly for no apparent
reason, the computer should be reset
by unplugging the computer and
plugging it back in. This could prevent
a service call.
COMPUTER PROGRAMMING INSTRUCTIONS
1. Turn the computer on by pressing the
Power
switch (or ON/OFF
ON
OFF
switch).
2. Enter the programming mode by pressing
the Program Mode switch
.
Code
appears in the left display. If you enter the
programming mode by mistake, press the
switch again to exit the programming
mode.
NOTE
: If you try to enter the pro-
gramming mode while the computer is
cooking, the display will flash
busy
busy
busy
busy
.
3. Enter the number
1650
by pressing the
number keys.
4.
sp----r
(Setpoint) will appear in the left
display. Any previously programmed
temperature setpoint will appear in the
right display. To change the setpoint, en-
ter the desired setpoint temperature using
the number keys. For CE units, the highest
setpoint allowed is 370ºF (188ºC). For
Non-CE units the number is 375ºC