45 SERIES GAS FRYERS
CHAPTER 2: INSTALLATION INSTRUCTIONS
2-6
•
For units equipped with thermostat
controls, refer to the Thermostat Cali-
bration instructions in Chapter 7.
•
For units equipped with other types of
controllers, refer to the Set Point pro-
gramming instructions in Chapter 3.
2.5
Converting to Another Gas Type
Your fryer is configured at the factory for ei-
ther natural gas or Propane (LP) gas.
If you desire to switch from one type of gas to
another, a gas conversion kit must be in-
stalled by a Factory Authorized Service
Center technician.
DANGER
Switching to a different type of gas
without installing the proper
conversion kit may result in fire or
explosion!
NEVER ATTACH YOUR FRYER TO A
GAS SUPPLY FOR WHICH IT IS NOT
CONFIGURED!
Non-CE Gas Conversion Instructions
Call
Frymaster
Frymaster
Frymaster
Frymaster
Service (1-800-551-8633) to
determine the conversion kit appropriate for
your configuration and altitude. Contact your
local FASC to order the kit and arrange for
installation.
CE Gas Conversion Instructions
1. Between G20- and G25-type Natural Gas,
adjust the gas pressure at the regulator.
(Refer to the CE Standard Burner Mani-
fold Gas Pressure Chart.) Do not change
the orifice or pilot.
2. Between a 2
nd
family gas (G20 or G25)
and a 3
rd
family gas (G31 Propane):
a. Change the orifices.
b. Change the pilot.
c. Change the gas valve regulator.
d. Adjust the manifold pressure.
3.
Remove the rating plate and install a new
one. Call your local service agency or
KES for a new rating plate.
4.
If the destination language changes, re-
place the labels. Call you local service
agency of kitchen equipment supplier for a
label kit. The language of reference will
be on the corner of the label.
The following gas-conversion components and
kits are available from your FASC:
Propane (G31) to Natural (G20/G25)
Regulator only: P/N 810-1288
Pilot, regulator, and orifices kit: P/N 826-1201
Natural (G20/G25) to Propane (G31)
Regulator only: P/N 810-1292
Pilot, regulator, and orifices kit: P/N 826-1200
