Fronius Symo GEN24 10.0, Operating Instructions Manual, Page: 69 / 120

7
L1´ Phase conductor
N´ Neutral conductor
N´ PEN conductor
NOTE!
The PEN conductor must be produced
with ends that are permanently marked
blue, according to the national provi-
sions, and have a cross section of
10 mm².
8
Fasten the ground conductor (PE) and
PEN conductor to the ground electrode
terminal using a screwdriver (TX20) and a
torque of 1.8-2 Nm.
9
Insert the OP terminal into the OP slot until
it engages. Tighten the cap nut of the
strain-relief device to the torque specified
by the manufacturer.
69
EN