Fronius MagicWave 1700, Operating Instructions Manual, Page: 168 / 287

60
- Press the “Mode” button (1) to select either 2-step mode (2) or 4-step mode (3)
(1)
(2)
(3)
- While pressing and holding the Store button (13), press the “Mode” button (1)
- The first set-up parameter is displayed (e.g. “SPt”)
Important! The first parameter to be displayed is always the one that was the last to be
selected the last time the set-up menu was accessed.
- Select the set-up parameter “2nd” with the parameter selection buttons (8) and (9).
Level 2: TIG set-up parameters
Select
“Parameter 2nd”
Once the set-up parameter “2nd” has been selected:
-
While pressing and holding the Store button (13), press the “Mode” button (1)
- The first set-up parameter of Level 2 is displayed (e.g. “SFS”)
Important! The first parameter to be displayed is always the one that was the last to be
selected the last time the set-up menu was accessed.
Accessing
Selecting and
altering the set-
up parameter
- Select the desired set-up parameter with the parameter selection buttons (8) and
(9).
- Alter the value of the set-up parameter with the adjusting dial (7)
Exiting and
saving - Press the Store button (13) twice
Available set-up
parameters
SFS .... S pecial f our- s tep ... OFF / 1 (Variant 1)
Factory setting: OFF
Variant 1 of the special 4-step operating is described in the section headed: “TIG
operating modes”.
C-C ..... C ooling unit c ontrol ... (optional) ... AUT / ON / OFF
Factory setting: AUT
In the “AUT” position, the coolant return-flow temperature is checked after a 2-minute
weld off-time. If the return-flow temperature is less than 50 °C, the cooling unit is
switched off automatically.
“AUT” position ...... Cooling unit is switched off 2 minutes after the end of welding
“ON” position ........ Cooling unit is ON all the time
“OFF” position ...... Cooling unit is OFF all the time