Fronius Calibration system 2.0, Operating Instructions Manual

Page: 82 / 100

Calibrating WeldCube Connector
Overview WeldCube Connector with current/voltage measurement:
- WeldCube Connector U/I
- WeldCube Connector Advanced
A TPS 500i power source is used when calibrating the WeldCube Connector.
System layout as shown in the figure on page 83 with the following exceptions:
- no wirefeeder
- no WCC Euro wire sensor
- no Euro/central connector adapter with Tuchel socket
- the (+) power cable from the calibration system is connected directly to the
(+) current socket on the power source.
WeldCube Connector with current/voltage measurement and wire speed meas-
urement (Euro):
- WeldCube Connector U/I/WFS Euro
- WeldCube Connector Ad OPT/WCC Wire Sensor EUR
The WeldCube Connector is calibrated using a
TPS 500i power WF 25i / 30i with Euro connection
or
TPS 500i power WF 25i / 30i + adapter ZA FSC-S-G/Euro STD
WeldCube Connector with current/voltage measurement and wire speed meas-
urement (TSt c, VR 5000):
- WeldCube Connector U/I/WFS WSM
- WeldCube Connector Ad OPT/WCC Wire Sensor WSM
The WeldCube Connector is calibrated with the existing TransSteel system com-
ponents.
System layout as shown in the figure on page 83 with the following exceptions:
- TSt + VR 5000 instead of TPS 500i + WF 25i / 30i
or
TSt c with integrated wire drive
- no WCC Euro wire sensor, wire sensor installed in VR 5000 or in TSt c
- no Euro/central connector adapter with Tuchel socket
Connecting the
TPS /i power
source, Weld-
Cube Connector
and calibration
system
1
Plug the mains cable into the calibration system
2
Plug the mains cable into the grid
3
Switch on the mains switch
82