Installation | 5
M2050222_en | Installation instructions Lambdamat LM 1500 KOM
55
5.9 Power connection and wiring
DANGER
When working on electrical components:
Risk of electrocution!
When work is carried out on electrical components:
r
Always have work carried out by a qualified electrician
r
Observe the applicable standards and regulations
Ä
Work must not be carried out on electrical components by unauthorised persons
r
Lay the cables from the components through the cable ducts to the control cabinet.
r
Wire the connections according to the wiring diagram.
r
Ensure that there is strain relief for all cables in the control cabinet.
Information about laying the cables
▪ Tie any loose hanging cables to the drive motors using cable ties. The cables must not
come into contact with the stoker duct.
5.9.1 Potential equalisation
r
The potential equalisation must comply with current directives, regulations and
standards
r
Establish potential equalisation to the induced draught fan and FGR fan
5.10 Connecting the hydraulic cylinder
r
Connect the piping to the hydraulic unit.
TIP: Fit a bypass line that can be shut off immediately in front of the hydraulic cylinder.
