Installation | 5
M2050222_en | Installation instructions Lambdamat LM 1500 KOM
31
5.6.9 Fitting the side panels
Use the supplied countersunk head screws with slit and cup washers to fit the side
panels.
NOTICE! Only hand-tighten screws to avoid damage and deformation to the side
panels!
r
Cut out all the pre-cut perforations required for the boiler on the side panels.
r
Fit the side panels as shown to the left and right-hand side of the boiler.
r
Bend the pre-cut flaps 90° inwards by hand.
r
Cut out the thermal insulation at the perforations for the automatic ignition.
r
Fit the brackets of the compressed air tank to the heat exchanger (A).
Ä
These are fitted to the stop side of the reversing chamber door.
