Spread Spectrum Wireless Data Transceiver User Manual
(B)
MCU
SPEED
Use this menu to set the speed of the Micro Controller Unit in the transceiver. The default setting is 0 for
low speed.
The following table describes the MCU speed settings.
Setting
Description
Notes
0
Low speed
Reduces current consumption
1
High speed
Required for 230 Kbaud data port rate
Radio Statistics
The Radio Statistics in the Main Menu allows the user to view data transmission statistics that have been
gathered by the transceiver during the most recent session. This is valuable when the user needs to know
the signal strength, noise levels and/or the distance of the link between transceiver. Statistics are
gathered during each data link and are reset when the next link begins.
Show Radio Statistics
Selecting (4) Show Radio Statistics from the main menu displays the following window.
N
UMBER OF
D
ISCONNECTS
If, during the course of performing a link test, the link between the Master and the Slave is broken and the
radios lose Carrier Detect, it is recorded in the Number of Disconnects value. The value indicates the total
number of disconnects that have occurred from the time the link test started until the radio was put into
setup mode. Under ideal operating conditions, the number of disconnects should be 0. One or more
disconnects may indicate a weak link, the presence of severe interference problems or loss of power to
any of the radios in the link.
LUM0002AD Version
6.1
40
