Spread Spectrum Wireless Data Transceiver User Manual
Set Operation Mode
1.
Selecting
0
Set Operation Mode from the Main Menu displays the following window.
2.
Select the appropriate operation mode by typing the associated number or letter after
Enter
Choice
.
3.
When the selection is accepted the Set Modem Mode menu will refresh and display the updated
mode.
4.
Press the
Esc
key once to return to the main Setup menu.
U
SING THE
P
OINT
-
TO
-P
OINT
S
LAVE
/M
ASTER
S
WITCH ABLE
O
PERATION
M
ODE
(M
ODE
6)
When using the Point-to-Point Slave/Master Switch able operation mode, it is important to remember the
following items:
•
This mode only works through the data port with diagnostics turned off.
•
The transceiver remains in Slave mode until called by another transceiver in its Call Book or
instructed to call another transceiver through an AT command. All script file or AT commands
issued to the transceiver in switch able operation mode must be in ALL CAPS.
•
If the DTR line is asserted when the command is given, it will call out immediately. Conversely,
after an AT command is given, the transceiver will not call out until the DTR goes high.
•
The Master will disconnect when DTR goes low.
•
The user may change settings in the user interface without using the Setup button.
•
Predetermined script files may be used which allow any of the transceiver's settings to be
changed upon execution of that file. This allows the user to establish push button command sets
that instruct the transceiver to call a predetermined Slave.
LUM0002AD Version
6.1
20
