Mainboard Users Manual
34
If the auto-detected parameters displayed do not match the ones
that should be used for your hard drive, do not accept them. Press
the
<N>
key to reject the values and enter the correct ones manually
in the Standard CMOS Setup screen.
Note: If you are setting up a new hard disk drive that supports
LBA mode, more than one line will appear in the param
eter box. Choose the line that lists LBA for an LBA drive
.
Do not choose Large or Normal if the hard disk drive is
already fully formatted when you installed it. Select the mode that
was used to format it.
!
IDE Primary/Secondary Master/Slave:
If you leave this item
at Auto, the system will automatically detect and configure
any IDE devices it finds. If it fails to find a hard disk, change
the value to Manual and then manually configure the drive
by entering the characteristics of the drive in the items below
(Capacity, Cylinder, Head, Precomp, etc.). Refer to your
drives documentation or look on the drive if you need to
obtain this information. If no device is installed, change the
value to None.
!
Access Mode:
This item defines some special ways that can be
used to access IDE hard disks such as LBA (Large Block
Addressing). Leave this value at Auto and the system will
automatically decide the fastest way to access the hard disk
drive.
Press
<Esc>
to close the IDE device sub-menu and return to the
Standard CMOS Features page.
Standard CMOS Setup
