Mainboard Users Manual
28
S/P DIF Output Select Jumper (J11)
1-2 for RCA Video Output.
3-4 for S/P DIF Output.
Clear CMOS Jumper (J10)
You may need to clear the CMOS if your system cannot boot up because
you forgot your password, the CPU clock setup is incorrect, or the CMOS
settings need to be reset to default values after the system BIOS has been
updated.
Refer to the following solutions to reset your CMOS setting:
Solution A
1. Power off the system and disconnect the power cable.
2. Place a shunt to short pin 1 and pin 2 of J10 for five seconds.
3. Place the shunt back to pin 2 and pin 3 of J10.
4. Power on the system.
Solution B
If the CPU clock setup is incorrect, you may not be able to boot up. In this
case, follow these instructions:
1. Turn the system off, then on again. The CPU will automatically
boot up using standard parameters.
2. As the system boots, enter BIOS and set up the CPU clock.
DOC BIOS Select Jumper (J4)
1-2 Disable.
2-3 Enable.
Host Frequency Select Jumper (J13)
Frequency selection for the clock generator jumper setting.
Note:
If you are unable to enter BIOS setup, turn the system on and off a
few times.
Installing System Memory
