11
Before moving the incline trainer, unplug the power
cord.
Note: It may be necessary to disconnect a CATV
cable and a network wire from the incline trainer, de-
pending on how far the incline trainer will be moved.
Due to the size and weight of the incline trainer,
moving it requires two or three persons. Hold the
metal frame firmly in the location shown at the right.
CAUTION: To decrease the possibility of damage to
the incline trainer or of injury, do not lift the frame
by the front cover.
Carefully roll the incline trainer on
the wheels to the desired location and then lower it back
to the level position.
CAUTION: To reduce the risk of
injury, use extreme caution while moving the incline
trainer. Do not attempt to move the incline trainer
over uneven surfaces.
Frame
Front
Cover
Wheels
HOW TO MOVE THE INCLINE TRAINER
Unplug the power cord.
Remove the four Console Plate
Screws (112) and the Basic Console Plate (not shown).
Remove the five #8 x 3/4" Screws (A) from the back of the
Basic Console (not shown), and remove the Basic Console
from the incline trainer. Disconnect all wires connecting the
Basic Console to the incline trainer.
Insert the wire harness, the TV cable, and the ground wire
into the bottom of the TV Console (137) as you slide the TV
Console onto the bracket on the Handrail (103). Connect the
wire harness, the TV cable, and the ground wire to the back
of the TV Console.
Make sure to connect the connectors
properly.
Align the indicated five holes in the back of the TV Console
(137) with the five holes in the bracket on the Handrail (103).
Attach the TV Console with five #8 x 3/4" Screws (A).
Be
careful not to pinch any wires.
Attach the TV Console Plate (118) to the TV Console (137)
with four Console Plate Screws (112).
118
112
103
A
Ground
Wires
137
TV Cable
Wire
Harness
If you purchase the Workout TV console, follow the steps below to assemble the console.
