8
4. Partially tighten two 1/2" x 4 1/2" Bolts (96) with two 1/2"
Star Washers (124) through the top of the bracket near
the right Upright (93) and into the Base Frame (56);
do
not tighten the Bolts yet. Be careful not to pinch any
wires.
Repeat this step on the left side of the incline
trainer.
Then, tighten the 1/2" x 4 1/2" Bolts (96) and the 1/2" x
2 1/2" Bolts (95) on both sides.
95
93
56
96
124
4
3
3. Partially tighten two 1/2" x 2 1/2" Bolts (95) through the
bracket near the right Upright (93) and into the Base
Frame (56);
do not tighten the Bolts yet. Be careful
not to pinch any wires.
Repeat this step on the left side of the incline
trainer.
93
56
95
2
2. Locate the Frame Wire Harness (133) and Upright Wire
Harness (119) in the Upright (93) access hole.
Connect the Frame Wire Harness (133) and Upright
Wire Harness (119) at the front of the Uprights (93).
See
the inset drawing. The connectors should slide to-
gether easily and snap into place.
If they do not, turn
one connector and try again.
IF YOU DO NOT CON-
NECT THE CONNECTORS PROPERLY, THE CON-
SOLE MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER.
Attach the Access Plate (130) to the Uprights (93) with
two #8 x 1/2" Machine Screws (129).
130
133
119
129
93
133
119