7
Assembly requires two persons.
Set the incline trainer in a cleared area and remove all packing materials. Do
not dispose of the packing materials until assembly is completed
. Assembly can be completed using a 3/8"
hex key, a 7/32" hex key, and a Phillips screwdriver.
For help identifying assembly hardware, see the drawings below.
Note: Some small parts may have been pre-
assembled. To avoid damaging parts, do not use power tools for assembly.
*These Screws are included only with the Workout TV console INCLINE TRAINER.
Console Plate Screw
(112)–4*
#8 x 3/4" Screw (16)–5*
1/2" Star
Washer (124)–4
#8 x 1/2"
Machine Screw
(129)–2
1/2" x 2 1/2" Bolt (95)–4
1/2" x 4 1/2" Bolt (96)–4
3/8" x 1" Bolt (51)–4
5/16" x 2" Bolt (102)–4
ASSEMBLY
1. Place the Uprights (93) near the front of the Base Frame
(56) as shown.
As you slide the Uprights (93) onto the Base Frame (56),
insert the Frame Wire Harness (133) into the large hole
in the Upright.
Be careful to avoid pinching the wire.
Align the holes in the Uprights (93) with the holes in the
Base Frame (56).
93
56
1
Hole
RIGHT
LEFT
133
