F3Dn Service Manual Parts Replacement / Section 2.4
For Technical Support, Call 800-537-2653. Copyright
2006 Franke, Inc. All rights reserved.
2.4
Door Lift Slide Replacement
[Part No. 18000673]
1)
Roll the unit out to allow access to rear service panel.
2)
Disconnect power at outlet. [Pull power cord plug.]
3)
Remove two screws securing service access panel.
4)
Detach the Black and Red electric power connections
from the Slide Lift and Door [Open] Motors.
5)
Remove [and save] the spring retaining clip from the left
side Door Rotation Block Pin. Slip round loop over pin
then remove. Release tension on spring and allow it to
hang from the right side spring mounting screw.
6)
Remove the spring retaining clip from the right side of
the white plastic Door Cam Link. Remove that link and
the two small plastic shaft spacers.
7)
From the front side rotate product doors down to expose
the shaft mounting screws on both doors.
8)
Using a 1/8” [3 mm] Allen/hex wrench, remove the three
screws that attach each door to its pivot shaft.
9)
Slide the Door Frame off the left door shaft.
10) Remove the rubber seal cover from both Door Shafts.
11) Using the 5/32” [4 mm] Allen/hex wrench, remove the
four Door [Open] Motor mounting screws. Removing the
two top screws will separate the Door Open Sensor &
Bracket from the motor assembly. It can hang down from
cable.
12) Using the 5/32” [4 mm] Allen/hex wrench, remove the
four Door Lift Motor mounting screws. [This is the bottom
motor.]
13) Carefully remove the motor and gearbox assembly from
the machined aluminum Door Slide Lift Assembly.
14) Remove the Door Lift Shaft from the Slide Bearing
Assembly.
15) Using a ¼” [6 mm] box wrench or socket, remove the
four Door Lift Slide mounting bolts.
16) Pull Door Lift Slide sub-assembly [with shafts] out of
cabinet and place on a convenient work surface.
17) Using a ’C’ ring pliers, remove both retaining rings on the
freezer side of each door mounting shaft. [Back retaining
ring on each shaft should stay in place.]
18) Using a rubber mallet, tap door shafts out of Door Lift
Slide bearings.
19) Take the replacement Door Lift Slide and use your
rubber mallet to tap door shafts back into place.
20) Replace the two ‘C’ Rings on each shaft.
21) Reposition the sub-assembly back though the cabinet
penetrations.
[Photo 1]
Remove the spring clip retainer
from left side door rotation block
pin, then relieve spring tension.
[Photo 2]
Remove the two upper motor
mounting screws first.
[Photo 3]
Open load doors from the front
and remove three shaft-
mounting screws on each
.
.
Ø
