F3Dn Service Manual Parts Replacement / Section 2.6
For Technical Support, Call 800-537-2653. Copyright
2006 Franke, Inc. All rights reserved.
2.6 Drum Rotor Motor Replacement
[Part No. 19000161]
1)
Roll unit out to allow access to rear service panel.
2)
Disconnect power at outlet. [Pull power cord plug.]
3)
Remove two screws securing service access panel.
4)
Disconnect both motor harness power connections.
5)
Using a 5/32” [4 mm] Allen Wrench, remove the four
motor mounting screws.
6)
Remove motor by pulling straight out. Motor Rotor Block
will remain in place.
7)
Install new Drum Rotor Motor [P/N 19000161]. Ensure
motor gear case drive shaft engages rectangular slot in
plastic Rotor Drive Shaft.
8)
Replace and tighten the four motor mounting screws
using your 5/32” [4 mm] Allen Wrench.
9)
Reattach power leads to motor: [Red = positive, Black =
negative]
10) Reconnect unit to power supply.
11)
Test
for proper motor operation by:
12) Turning ON main power switch & pressing LANE-
POWER touch pad on control overlay.
13) If LOAD READY light is on, position empty fry basket
under hopper to activate loading cycle in AUTO Mode. In
MANUAL Mode press MANUAL DISPENSE touch pad.
14) If Fry Hopper is empty, place screwdriver or knife blade
in front of load sensor to trick the dispenser.
15) Position an empty fry basket in the fill chute.
16) If lane dispenses fries [if present] or if rotors turn
smoothly in an attempt to dispense fries, the motor is
working properly.
17) Close rear service access panel and return F3Dn
Dispenser to normal operating location
.
[Photo 1]
Disconnect motor power
leads.
[Photo 2
]
Remove the four motor
mounting screws.
Rev. 1 9/06
@
Tools Required:
Ø
3/8” [10 mm] flat blade
screw driver
Ø
5/32” [4 mm] Allen
Wrench
