F3Dn Service Manual Parts Replacement / Section 2.10
For Technical Support, Call 800-537-2653. Copyright
2006 Franke, Inc. All rights reserved.
2.10 Door-Closing Spring & Bushing
Replacement [Part No. 19001676]
1)
Roll the unit out to allow access to rear service panel.
2)
Disconnect power at outlet. [Pull power cord plug.]
3)
Remove two screws securing service access panel.
4)
Locate broken or weak/extended Door-Closing Spring.
5)
Remove [and save] the spring retaining clip from the left
side Door Rotation Block Pin. Slip round loop over pin
then remove.
6)
Remove and discard partial, extended or broken spring.
7)
Using a 1/8” [3 mm] Allen wrench, remove the right side
spring mounting screw and discard remainder of spring.
8)
Install the new Door Spring with plastic bushings in end
loops [P/N 19001676] by replacing right side retaining
screw and tightening with 1/8” [3 mm] Allen wrench.
9)
Using both hands, extend spring eye to left side Door
Rotation Block Pin. [
CAUTION
: Spring will be under
tension and may snap back.]
10) Replace spring retaining clip and lock in place over pin.
Test
the replacement Door-Closing Spring as follows:
11) Remove Fry Hopper and Loading Chute from Lane.
12) Manually rotate product doors against spring tension.
Ensure both doors open in unison and 90 degrees down
to full open.
13) Reassemble loading chute and fry hopper, then close the
freezer door.
14) Plug in unit power cord to power supply.
15) Turn on main power switch & pressing LANE-POWER
touch pad on operator panel.
16) If LOAD READY light is on, position empty fry basket
under Hopper to activate fry loading cycle in AUTO
Mode. In MANUAL Mode press MANUAL DISPENSE
touch pad.
17) If Lane properly dispenses fries, replacement spring is
working properly.
18) Close rear service access panel and return F3Dn
Dispenser to normal operating location.
[Photo 1]
By hand remove the spring clip
retainer from left side door
rotation block pin.
[Photo 2
]
Use a 1/8” Allen Wrench to
remove and later tighten right
side spring retaining screw.
[Photo 3]
Test new spring by manually
opening product doors against
spring tension. Both doors
should rotate down against
resistance of the extension
spring.
Rev. 1 9/06
Ø
