F3Dn Service Manual Component Adjustments / Section 3.3
For Technical Support, Call 800-537-2653. Copyright
2006 Franke, Inc. All rights reserved.
3.3 Adjusting Automation Assy. Alignment
Problem:
Product Dispenser
Door Frame does not
align with or seal against rectangular opening in the
freezer compartment bottom.
1)
F3Dn Dispenser should be OFF and the freezer
compartment fully defrosted before proceeding.
2)
If not already removed, open freezer compartment door
and remove the Lane Fry Hopper and Loading Chute in
question.
3)
Roll the unit out to allow access to rear service panels.
4)
Disconnect power at outlet. [Pull 120-Volt plug.]
5)
Remove screw securing back service access panel.
6)
Using a 7/16” [11 mm] box wrench, barely loosen all
eight Automation Assembly mounting bolts. This
assembly attaches to the rear frame with right and left
‘L’ channels.
7)
The bolt holes in the ‘L’ channels are all slotted, to
provide in-out or up-down adjustment of the Automation
Assembly.
8)
Minimally tighten the four channel-to-Automation
Assembly bolts and manually position and level
assembly front-to-back, so the product loading door
frame is centered in freezer bottom opening. [
Note
:
Check this alignment from front of unit.]
9)
Minimally tighten the four ‘L’ channel-to-rear-frame
mounting bolts and adjust height of the Automation
Assembly so that the dispenser doors just “kiss” the
freezer bottom. [Check this alignment from front of unit.]
10) Tighten all eight 7/16” [11 mm] bolts securely and
recheck dispense door-to-freezer bottom seal and fit. If
further adjustment is required, repeat steps 6 thru 10.
11) Close rear service access panel.
12) Move unit back into position.
13) Re-install Loading Chute and Lane Fry Hopper.
14) Plug in unit power cord to 120-volt power supply.
15) Turn ON main power switch and press both Lane-
POWER touch pads on front control overlays.
16) When LOAD READY light is on, position an empty fry
basket under Hopper to verify operator is satisfied with
results of this adjustment procedure. [Note: LANE
POWER must be in AUTO Mode or you will need to
press the MANUAL DISPENSE touch pad to activate fill
cycle.]
[Photo 1]
Product Dispenser Door Frame
must be centered in and seal
against plastic freezer bottom.
[Photo 2
]
Loosen four assembly-to-side ‘L’
channel mounting bolts to adjust
front-to-back position and level
of door frame.
[Photo 3]
Loosen four ‘L’ channel-to-frame
mounting bolts to adjust height
and seal of Door Lift Assembly.
Rev. 2 11/06
Ø
