F3Dn Service Manual Parts Replacement / Section 2.13
For Technical Support, Call 800-537-2653. Copyright
2005 Franke, Inc. All rights reserved.
2.13 Door-Open Sensor Replacement
[Part No. 19000192]
1)
Roll the unit out to allow access to rear service panel.
2)
Disconnect power at outlet. [Pull plug.]
3)
Using the medium Phillips screwdriver, remove two
screws securing service access panel.
4)
Disconnect Door-Open Sensor cable lead from the wiring
harness.
5)
Using the 5/32” [4 mm] Allen/hex wrench, remove the top
two [Door Open] motor mounting screws only.
6)
Remove the Door Open Sensor & Bracket from the
motor assembly. Slide the sensor bracket to the right,
clearing the sensor flag or fin. Unscrew sensor mounting
screws to remove sensor from the bracket.
7)
Position new Door Open Sensor [P/N 19000192] on the
mounting bracket and attach using the two screws just
removed.
8)
Position new sensor and bracket over motor mounting
holes. Ensure actuating flag is spaced midway within
sensor slot.
9)
Replace and tighten the two upper motor mounting
screws using the 5/32” [4 mm] Allen/hex wrench.
10) Reattach the new Door Open Sensor cable lead to the
motor wiring harness.
Test
the replacement Door-Open Sensor as follows:
11) Plug in unit power cord to power supply.
12) Turn on main power switch & pressing LANE POWER
touch pad on front control panel.
NOTE
: Make sure Lane
is in AUTO Mode.
13) If LOAD READY light is on, position empty fry basket
under Hopper to activate fry loading cycle.
14) If Lane properly dispenses fries, replacement Door-Open
Sensor and dispensing assembly is working properly.
15) Close rear service access panel and return F3Dn
Dispenser to normal operating location.
[Photo 1]
The Door Open Sensor &
Bracket is mounted with the
upper [Basket Lift] motor
mounting screws.
[Photo 2]
Use 5/32” Allen/hex wrench to
remove and tighten mounting
screws.
Rev. 2 10/06
Ø
