F3Dn Service Manual Parts Replacement / Section 2.8
For Technical Support, Call 800-537-2653. Copyright
2006 Franke, Inc. All rights reserved.
2.8 Door [Open] Motor Replacement
[Part No. 18000558]
1)
Roll the unit out to allow access to rear service panel.
2)
Disconnect power at outlet. [Pull power cord plug.]
3)
Remove two screws securing service access panel.
4)
Remove [and save] the spring retaining clip from the left
side Door Rotation Block Pin. Slip round loop over pin
then remove. Release tension on spring and allow it to
hang from the right side spring mounting screw.
5)
Remove the spring retaining clip from the right side of
the white plastic Door Cam Link. Remove that link. [You
don’t need to remove the small plastic shaft spacers.]
6)
Using the 5/32” [4 mm] Allen/hex wrench, remove the
four motor mounting screws, beginning with the two TOP
screws.
7)
Removing the longer top screws will separate the Door
Open Sensor & Bracket from the motor assembly.
8)
Detach the two motor electric power connections.
9)
Install new motor assembly [P/N 18000558] starting with
the two bottom mounting screws.
10) Remount Door Open Sensor & bracket using the two
upper motor mount screws.
11) Reconnect the two motor electric power connections:
[Red = positive; Black = negative].
12) Replace white plastic Door Cam Link, with Stop Screw to
the right side. [
Note
: Make sure bushings and spacers
are on both left and right cam pins, before replacing link.]
13) Attach the spring retainer clip to right side Door Rotation
Block pin.
14) Using both hands, extend spring eye to left side Door
Rotation Block Pin. [
CAUTION
: Spring will be under
tension and may snap back.] Plastic bushings must be
installed in spring end loops, before mounting the spring.
15) Replace spring retaining clip and lock in place over pin.
Test
the replacement Door [Open] Motor as follows:
16) Plug in unit power cord to power outlet.
17) Turn on main power switch & pressing LANE-POWER
touch pad on front control overlay.
18) If LOAD READY light is on, position empty fry basket
under Hopper to activate fry loading cycle in AUTO
Mode. In MANUAL Mode press MANUAL DISPENSE.
19) If Lane properly dispenses fries, replacement Motor and
dispensing assembly is working properly.
20) Close rear service access panel and return F3Dn
Dispenser to normal operating location.
[Photo 1]
Remove the spring clip retainer
from left side door rotation block
pin, then relieve spring tension.
[Photo 2]
Remove the two upper motor
mounting screws first.
[Photo 3]
Ensure motor drive aligns with
the slot in the slide plate counter
bore.
Rev. 1 9/06
Ø
