![Fractal Audio AXE-FX II Owner'S Manual Download Page 88](http://html.mh-extra.com/html/fractal-audio/axe-fx-ii/axe-fx-ii_owners-manual_2326262088.webp)
EFFECTS GUIDE
Doc v6.00c
77
TIME ALPHA
– Sets the acceleration of the rate of time change across the taps. A setting of 0% results in no
effect, while 100% results in an extreme effect.
Ex:
Decreasing,
Moderate Alpha
Ex:
Decreasing,
Higher Alpha
AMPLITUDE SHAPE
– This specifies how the volume increases or decreases from tap to tap.
AMPLITUDE ALPHA
– Sets the acceleration of the rate of volume change across the taps.
A setting of 0% results in no effect, while 100% results in an extreme effect.
PAN SHAPE
–
This specifies how the pan changes from tap to tap as they progress.
PAN ALPHA
– Sets the acceleration of the rate of pan change across the taps.
A setting of 0% results in no effect, while 100% results in an extreme effect.
TIME RANDOMIZE
– Controls how much the tap spacing is randomized.
Megatap Mix Parameters
The
Megatap
block has a
MIX
page with
MIX
,
LEVEL
,
BALANCE
,
BYPASS MODE
, and
GLOBAL MIX
parameters.
See
Common Mix Parameters
on p.
117
for more information.
5.18
Mixer [MIX]
The
Mixer
block contains a simple, linear mixer able to combine up to four stereo signals into either one stereo mix
or one mono mix. The mixer lets you fine-tune level blends or use
modifiers
(p. 124) to crossfade between
different effects or chains. Each pair of gain and balance controls corresponds to a row in the grid. For a more
thorough description of how Axe-Fx II mixers work, see section
16.8
, Mixology, on p.
160
.
Page 1 Parameters
GAIN 1
– Sets the level for the incoming signal from a block in
row 1
of the column left of the mixer.
BAL 1
– Sets the balance between left and right signals of the block in
row 1
of the column left of the mixer.
GAIN/BAL 2, 3, 4
– These pairs of controls respectively set the level and balance of incoming signals from
the blocks in rows 2, 3, and 4 of the column left of the mixer.
Page 2 Parameters
LEVEL
– Sets the level of the output mix.
OUTPUT MODE
– Specifies whether the outgoing mix should be stereo or summed to dual mono.
Each Axe-Fx II preset can use two fully independent
Mixer
blocks.
Summary of Contents for AXE-FX II
Page 1: ...Owner s Manual ...
Page 82: ...EFFECTS GUIDE Doc v6 00c 71 ...