EFFECTS GUIDE
Doc v6.00c
75
HALF
– Slows the Looper’s speed to half. Playback and normal or overdub recording are supported at half
speed. For double speed playback, record in half speed and then switch back to normal.
Note: Halving the
speed slightly reduces high-end frequency response.
Each Axe-Fx II preset can use one
Looper
block.
Looper Advanced Controls
MODE
– Selects the Looper mode, determining mono/stereo, looper length, and undo. Whenever you
change the mode, the looper memory will be entirely cleared.
MONO
– Recording and playback are in mono. Maximum loop length is 60 seconds. Undo is not possible.
STEREO
– Recording and playback are in stereo. Maximum loop length is 30 seconds. Undo is not possible.
MONO UNDO
– Recording and playback are in mono. Maximum loop length is 30 seconds. Undo works.
STEREO UNDO
– Recording and playback are in mono. Maximum loop length is 60 seconds. Undo works.
QUANT
– With quantize enabled, loop length is perfectly set to some whole number of beats) with reference
to the pulses of the Axe-Fx GLOBAL TEMPO (see p. 146)).
THRSH
– The Axe-Fx Looper can start recording automatically when the input exceeds a set level. Turn this
feature ON or OFF using this parameter.
THRSH LEVEL
– This sets the level which must be exceeded at the input of the Looper for recording to start
automatically.
DUB MIX
– Actually located on the Looper’s MIX page, this determines how much layers are reduced when
you
STACK
new layers. If you never want old layers to decay, set this to 100%, but be aware that adding
additional layers in this way can result in excessive signal and clipping.
Looper Mix Parameters
The
Looper
has a
MIX
page with
LEVEL, BALANCE,
and
BYPASS MODE
parameters.
See
Common Mix Parameters
on p.
117
for more information.
Summary of Contents for AXE-FX II
Page 1: ...Owner s Manual ...
Page 82: ...EFFECTS GUIDE Doc v6 00c 71 ...
