Fortress Bridge: Command-Line Interface
100
The commands that configure and delete Trusted Devices are
valid only in GW (gateway) mode (refer to Section 6.1.1 for
more detail).
NOTE:
Trusted De-
vices must be as-
signed static IP
addresses.
6.5.1.1
Adding Trusted Devices in the CLI
Add Trusted Devices with the
add
td
command, as follows:
[GW]>
add td
{
-n
<
name
>}
{
-ip
<
IPaddr
>}
{
-m
<
MACaddr
>} {-p any|
<port1,port2,…>
}
in which
name
is a descriptive identifier for the Trusted Device,
IPaddr
is the Trusted Device’s network address, and
MACaddr
its MAC address. The
-p
switch specifies, by number, the
port(s) accessible through the Trusted Device (comma
delimited, without spaces), or that
any
port is accessible
through the Trusted Device.
CAUTION:
Specify-
ing that
any
port
can access a TD can
pose a
significant
secu-
rity risk.
Maximize network security by specifying the narrowest
possible port access for Trusted Devices.
You must configure a name and IP and MAC addresses for a
Trusted Device when you add it to the Bridge configuration.
You can leave out
-p
(port sets) argument to establish default
values for these settings. Trusted Devices have no ports open
by default.
6.5.1.2
Deleting Trusted Devices in the CLI
Delete a single Trusted Device or all Trusted Devices from
Fortress Bridge management with the
del
td
command, as
follows:
[GW]>
del td
{<name>|all}
6.5.2
SNMP Settings in the CLI
View the current SNMP configuration with
show
snmp
:
NOTE:
You cannot
configure SNMP
management on a For-
tress Bridge in
FIPS
op-
erating mode. Refer to
Section 3.6.1 for more
information about
Bridge operating modes
and to Section 6.4.5.5 for
details on changing it.
[GW]>
show snmp
Status:off
Contact:you@yourdomain
Location:Home
ROCommunity:public
RWCommunity:private
Enable SNMP (v1,2) management of the Fortress Bridge with
the
enable
command:
The Fortress MIB is included on the CD that shipped with the
Bridge and is also available from:
https://www.fortresstech.com/support/products_updates.asp
.
[GW]>
set snmp on
Disable SNMP on the Fortress Bridge with the
disable
command:
[GW]>
set snmp off
Configure the Fortress Bridge for use with SNMP (v1,2) with
the
set
commands:
Summary of Contents for ecure Wireless Access Bridge
Page 2: ......
Page 18: ......
Page 47: ...Fortress Bridge Configuration 37 NOTE For security ...
Page 87: ......