Fortinet Fortiwifi fortiwifi-60, Administration Manual

Page: 39 / 394

System status Changing the FortiWiFi firmware
FortiWiFi-60 Administration Guide 01-28006-0014-20041105
39
10 Type an IP address that the FortiWiFi unit can use to connect to the TFTP server.
The IP address can be any IP address that is valid for the network that the interface is
connected to. Make sure you do not enter the IP address of another device on this
network.
The following message appears:
Enter File Name [image.out]:
11 Enter the firmware image filename and press Enter.
The TFTP server uploads the firmware image file to the FortiWiFi unit and messages
similar to the following are displayed:
• FortiWiFi unit running v2.x BIOS
Do You Want To Save The Image? [Y/n]
Type Y.
• FortiWiFi unit running v3.x BIOS
Save as Default firmware/Run image without saving:[D/R]
or
Save as Default firmware/Backup firmware/Run image without
saving:[D/B/R]
12 Type D.
The FortiWiFi unit installs the new firmware image and restarts. The installation might
take a few minutes to complete.
Restoring the previous configuration
Change the internal interface address if required. You can do this from the CLI using
the command:
config system interface
edit internal
set ip <address_ipv4mask>
set allowaccess {ping https ssh telnet http}
end
After changing the interface address, you can access the FortiWiFi unit from the
web-based manager and restore the configuration.
• To restore the FortiWiFi unit configuration, see “Backup and restore” on page 121 .
• To restore IPS custom signatures, see “Backing up and restoring custom signature
files” on page 303 .
• To restore web content filtering lists, see “Backup and restore” on page 121 .
• To restore email filtering lists, see “Backup and restore” on page 121 .
• To update the virus and attack definitions to the most recent version, see
“Updating antivirus and attack definitions” on page 126 .
If you are reverting to a previous firmware version (for example, reverting from
FortiOS v2.80 to FortiOS v2.50), you might not be able to restore your previous
configuration from the backup up configuration file.