Fortinet Fortiwifi fortiwifi-60, Administration Manual

Page: 31 / 394

System status Session list
FortiWiFi-60 Administration Guide 01-28006-0014-20041105
31
3 In the Operation Mode field, select NAT/Route.
4 Select OK.
The FortiWiFi unit changes operation mode.
5 To reconnect to the web-based manager, you must connect to the interface
configured by default for management access.
By default in NAT/Route mode, you can connect to the internal interface. The default
internal interface IP address is 192.168.1.99.
Session list
The session list displays information about the communications sessions currently
being processed by the FortiWiFi unit. You can use the session list to view current
sessions.
Figure 4: Sample session list
Note: If the management IP address was on a different subnet in Transparent mode, you may
have to change the IP address of your computer to the same subnet as the interface configured
for management access.
From IP Set source IP address for list filtering
From Port Set source port for list filtering
To IP Set destination IP address for list filtering
To Port Set destination port for list filtering
Apply Filter Select to filter session list
Virtual Domain Select a virtual domain to list the sessions being processed by that virtual
domain. Select All to view sessions being processed by all virtual domains.
Total Number of
Sessions Total number of sessions currently being conducted through the FortiWiFi
unit.
Refresh icon. Select to update the session list
Page up icon. Select to view previous page in the session list
Page down icon. Select to view the next page in the session list.
Protocol The service protocol of the connection, for example, udp, tcp, or icmp.
From IP The source IP address of the connection.
From Port The source port of the connection.
To IP The destination IP address of the connection.
To Port The destination port of the connection.
Expire The time, in seconds, before the connection expires.
Delete icon. Select to stop an active communication session.