Manual - Formech 450DT V1.0 - 0317
21
Optional Extras and Accessories
Trolley - Self Assembly Instructions (optional) (continuation)
2. Place the top tray (this has four 25mm holes to locate the rubber feet for the machine) upside down on
the fl oor or a table to start the assembly process.
3. Take each of the four corner struts and secure the one end of each strut to the top tray with plain was-
hers and M6 button head screws, making sure that they are only fi nger tight at this stage. There are three
button screws per corner fi xing. Ensure the corner struts are positioned as illustrated below:
4. Take the assembled bottom tray, turn it upside down and lower
it until it rests onto the four corner struts. Fit the remaining fi xings
to the struts and lower tray with the remaining plain washers and
M6 button head screws. Tighten all 24 strut fi xings securely. Turn
the assembly over so that the 4 casters are on the fl oor and check
for stability.
5. When locating the machine on the trolley ensure the machine
rubber feet are located in the clearance holes of the trolley top.
Ensure that local lifting and handling procedures are applied.
6. Trolley securing. The machine must be attached to the trolley
by the securing screws and washers provided. The securing screws
are fi tted under the trolley top into the machine body. Ensure
these fi xings are tight and cannot become loose.
7. Once the trolley and machine have been placed in their ideal
position, the two locking castors need to be depressed to prevent
trolley movement.
ENSURE THAT LOCAL LIFTING AND HANDLING
PROCEDURES ARE APPLIED AND MONITORED BY A
PERSON RESPONSIBLE FOR HEALTH AND SAFETY.
