Manual - Formech 450DT V1.0 - 0317
12
Initial Requirements 450DT
Operating Procedure
1.
Ensure the machine is turned on.
2.
With the heater fully back, raise the table to the
top position by pulling the table lever closer to you.
3.
Place your mould onto the table. A sheet of
wire mesh is supplied with the machine to assist
with Vacuum air fl ow under the mould tool.
4.
Fix the mould tool in place. Lower the table by
pushing the table lever away from you.
5.
Open the material clamps (see general
arrangement) and raise the clamp frame.
Place the plastic material over the aperture.
6.
Pull the clamp frame down and close the
two material clamps. The plastic should
completely cover the white seals around the
aperture. Adjust the toggle clamp screws to
properly grip the plastic.
(1)
(1)
The rear of the clamp is spring loaded.
