Manual - Formech 450DT V1.0 - 0317
3
Thank you for choosing Formech.
Please read and follow the below safety instructions before attempting to install or operate your machine.
> Do not operate the machine until you have been trained and are fully conversant with it.
> Read and understand all of this user manual.
> This is a ‘single person operating’ machine.
> Check your supply voltage and frequency. Make sure it is compatible with your machine. Your machine’s
electrical specifi cation plate is next to the power inlet socket.
> You must ensure that the machine is properly earthed and fused.
> If your machine is not equipped with a moulded mains connector then note that:
The earth wire is GREEN with a YELLOW stripe.
The live wire is BROWN
The neutral wire is BLUE
> Only suitably qualifi ed personnel should make electrical connections.
> Turn off the machine and disconnect the power supply when the machine is not in use.
> The heater and pump on this model are not intended to be left running indefi nitely.
> Never remove any panels unless the electrical supply has been isolated.
> Always let the machine cool down before attempting to work on it. Some parts of the heater and heat
shield become extremely hot during operation.
> Note the safety warning labels situated on the panels. Never remove any warning labels from the machine.
> Note the ‘HOT SURFACES’ safety labelling on the heater & heater guard. These areas can become VERY
HOT.
> Only use the machine for vacuum forming plastic. It is not intended for any other purpose.
> Ensure that the area you are working in is properly ventilated and that you are aware of the potential
hazards from the plastics you are forming. It is the responsibility of the owner or designated responsible
person to assess the risks associated with any dangerous fumes given off and to determine any necessary
precautions required such as fume extraction. Contact your plastics supplier to gain information regarding
hazardous fumes.
> There is a risk of being burnt when handling heated plastics. Always wear suitable personal protective
equipment such as gloves.
> Ensure that the area surrounding the machine is clean and frequently cleared of fi nished product and any
scrap.
> This machine is fi tted with a dry running vacuum pump. Do not lubricate. Do not allow any liquid to enter
the vacuum system. Ensure that moulds are properly sealed to prevent ingress of dust into the vacuum
circuit. Severe damage may be caused if the above is not observed.
> Daily repetitive use of this or any other machine may lead to a) fatigue and loss of concentration b)
possible strains.
> Operators should be trained in the use of correct lifting techniques.
> Users of this machine should complete regular competence tests.
Safety
