ROOF PANELS & ROOF PANEL CAPS
Knock further into place to allow the roof panel to
be as flush as possible to the wall face.
75
75
Use expanding foam in the groove of all roof
panels.
79
79
Use expanding foam and knock the Front Roof
Panel Cap (AQ) into place. Ensure all faces are
flush to the front and side edges.
81
81
If there is a 2-5mm overhang on the side, don’t
worry. This will not affect the rest of the build.
78
78
Pre-drill and secure 5 x 35mm screws where the
adjoining panels intersect.
76
76
Repeat the same process as the first roof panel
using 4 x 150mm screws along the edge to fully
secure the roof. Then secure the second roof
panel’s other side edge with 2 x 150mm screws at
each corner.
77
77
Use 4 x 80mm screws into the front roof panel cap.
Use 3 x 35mm screws between the 80mm screws
to fully secure.
82
82
Insert the Back Roof Panel Cap (AQ). Use 4 x
125mm screws through the back roof panel cap
and into the wall panel’s. Use 3 x 35mm screws
between the 125mm screws to fully secure.
80
80
16
