Fore Systems forerunner series, Configuration Manual

Page: 235 / 352

ForeRunner ATM Switch Network Configuration Manual
A - 15
Confi
guring
SNMP
Configuring SNMP
1038 asxVPAISCleared This trap indicates that the Alarm Indication Signal
(AIS) has been removed from the incoming (terminat-
ing) virtual path. This trap is generated once when the
virtual path is declared to be in the inactive AIS state.
1039 asxVPRDIDetected This trap indicates that the Remote Defect Indication
(RDI) is detected on the incoming (terminating) virtual
path. This trap is generated once when the virtual path
is declared to be in the active RDI state.
1040 asxVPRDICleared This trap indicates that the Remote Defect Indication
(RDI) has been removed from the incoming (terminat-
ing) virtual path. This trap is generated once when the
virtual path is declared to be in the inactive RDI state.
1041 asxNonextendedModeViola-
tion This trap indicates that a Series D network module was
inserted into a switch board running in non-extended
mode. Multicast will not work on the Series D module
without removing all Series B modules and rebooting
the switch.
1042 asxUnsupportedNetwork-
Module This trap indicates that a unsupported network mod-
ule was inserted into a switch.
1049 asxIpFilterViolation This trap occurs when an incoming IP packet is unau-
thorized to enter the switch control port and has been
dropped.
1053 q2931AFRejectKnown This trap is generated whenever any q2931 UNI with
Address Filtering enabled rejects a Setup request
because the request matched a template with the
action “reject.” The variables sent in the trap identify
the source and destination UNI for the call.
1054 q2931AFRejectUnknown This trap is generated whenever any q2931 UNI with
Address Filtering enabled rejects a Setup request
because the address matched no template. The vari-
ables sent in the trap identify the source and destina-
tion UNI for the call.
1061 q2931CreationFailure This trap is generated whenever a switch fails to create
a UNI. This is most likely due to a resource limitation
on the switch.
Table A.2 - SNMP Traps Supported on the ForeRunner Switches (Continued)
Trap
Number
Trap Name Description