FOR-A HVS-350HS, Operation Manual, Page: 80 / 266

66
8-10-2. Transition Rate
The transition rate setting determines how long the transition takes in frames to complete.
(1) Press the TRANSITION RATE button above the PinP1 ON AIR button to display the
[TRANS] menu.
Users can also display the [TRANS] menu by quickly pressing the following buttons twice:
BKGD, KEY1, KEY2 and MIX in the NEXT TRANSITION block.
(2) Turn F1 to F4 to set the transition rate for each bus. To enter the rate in the KEYPAD,
press F1 or other related control-push button, enter the rate in the KEYPAD and then
press ENTER in the KEYPAD to store the new transition rate.
The transition rate can be set for each bus respectively as shown in the following menu
pages. Use the page up and down buttons to move between the menu pages. The setting
range is 0 to 999 on a frame basis.
TRANS : M/E : P/P : BLACK TRANS : 1/6
BKGD/BLK: =30 : =30 : =30 : =P/P :
TRANS : KEY1 : KEY2 : PinP1 : PinP2 : 2/6
RATE-M/E: =30 : =30 : =30 : =30 :
TRANS : DSK1 : DSK2 : DSK3 : DSK4 : 3/6
RATE-P/P: =30 : =30 : =30 : =30 :
8-10-3. Endpoint Processing for DVE Transitions
In DVE operations, differences in video delay times when entering and exiting DVE effects
can cause the video to appear choppy. This choppiness can be reduced by menu setting so
that the DVE effect always exits at the transition start and end points (
TRS EDGE
to OFF in
the [SETUP-PANEL-TRS CTRL] menu).
PANEL :BUSTYPE:TRS EDGE: FADER OFFSET : 1/2
M/E CTRL: =P/P : =
OFF :U=1.00 L=1.00 :