18
- ORIGINAL INSTRUCTIONS -
OPERATION
Switch on the machine by pressing the
POWER WITCH on the side panel. Pull out
the E-STOP BUTTON
and press the START/
RESET BUTTON.
Place the REAR ROLLER V-BLOCKS to the correct position based on manufacturer and reel diameter.
NOTE: The pre-positioned settings do not work for walking greens mowers with a rear drum only. SEE PAGE
38.
These positions are intended to be a starting position, you may need to move to a different pin location
if the selected location does not work. Note there are 2 sets of holes for the V-blocks, use the outer set for
wider reels and the inner set for narrower reels. The closer the v-blocks are to sides of the reels the more
rigid the mounting resulting in a higher quality grind. Record the position of the reel if the default positoin is
not used to use in the future.
STEP 1: PLACING THE CUTTING UNIT
PREPARE CUTTING UNIT
FOR SHARPENING
1.
Follow the cutting unit manufacturers' recommendations for proper maintenance when preparing the
cutting unit for sharpening.
2.
The reel to be sharpened should be thoroughly cleaned.
3.
If possible remove the bed bar, and wheels on walking greensmowers.
4.
Inspect, adjust and/or replace any worn or damaged bearings. Make sure reel bearings are adjusted
properly so the reel turns easily by hand. Because this grinder mounts the reel using the rear roller and
front roller, the bearings must be in good repair with no freeplay. The front and rear rollers must be
properly aligned parallel to the reel prior to grinding.
REEL POSITION
The reel should be positioned so that it is at a one o’clock,
or 20- 30° angle, position in reference to the grinding
wheel. Place the height locator bracket next to or under
the reel. Adjust the front roller clamp until the bottom of
the reel just touches the bracket.
Summary of Contents for 622 SO
Page 32: ...32 ORIGINAL INSTRUCTIONS...
