Foley 622 SO, Operator'S Manual

Page: 17 / 32

17
- ORIGINAL INSTRUCTIONS -
GETTING TO KNOW YOUR GRINDER
1. EMERGENCY STOP
BUTTON or E-STOP
CONTROLS
2. START/RESET BUTTON
5. SPIN SPEED
KNOB
3. TRAVERSE
SPEED KNOB
4. POWER SWITCH/FUSES
1. EMERGENCY STOP BUTTON or E-STOP
Push to remove all power to motor. To restore power, pull up out and press the START/RESET SWITCH.
2. START/RESET BUTTON
Resets the control which allow the operator to control motors.
3. TRAVERSE SPEED KNOB
Increases or decreases the speed of the grinding head traversing left and right, measured in feet per
second (ft/s).
4. POWER SWITCH AND FUSES (RIGHT SIDE OF MACHINE).
Turns OFF and ON the control and related components. Disconnect the cord at the wall outlet before
performing service. FUSES - Interrupts excessive current (blows) so that further damage by overheating or
fire is prevented.
THIS IS NOT A MAIN DISCONNECT!
5. SPIN SPEED KNOB
Increases or decreases the spin speed during the SPIN GRIND cycle.
6. INFEED SELECTOR: rotate to the left to control just the left infeed, rotate all way to the right to control
just the right infeed , rotate to the middle to infeed both side evenly.
7. PROGRAM SELECT: Press to select from the available programs.
7. PROGRAM SELECT
6. INFEED
6. INFEED
SELECT
CODE DESCRIPTION
BLANK OFF/ E-STOP
0 MACHINE ON -
READY
1-5 AUTO PROGRAMS
6 DOOR OPEN
7 NOT ON TRAVEL
SENOR (TO START
AUTO PROGRAM
1 (2SEC) RIGHT SIDE
INFEED STALL
2 (2 SEC) LEFT SIDE
INFEED STALL
DISPLAY CODES