TView Silver User’s Guide
Chapter 2
11
2.
Disconnect the current monitor cable from the "monitor out" port
at the rear of the computer.
3.
Connect the male DB-15 end of the supplied UniViewer
cable
to the port at the rear of the TView Silver labeled "Monitor In."
4.
For an IBM PC or compatible, connect the pass-through end of
the UniViewer
cable to the "monitor out" port at the rear of the
computer, the same port from which you disconnected the
current monitor cable in step 2. For a Macintosh or compatible,
connect the supplied Macintosh to VGA adapter to the
Macintosh Video Output port located at the rear of the computer,
the same port from which you removed the current monitor
cable in step 2.
Note: Steps 5 and 6 facilitate the use of the TView Silver in the
Presentation Mode.
5.
Connect the male end of your computer’s monitor cable to the
video pass-through port on the UniViewer
cable. This port is
located on the UniViewer
cable itself, at the end of the cable
that is connected to the “Monitor out” port on the computer.
6.
Connect the female end of the monitor cable to the monitor.
7.
Connect the power adapter to the rear of the TView Silver. Plug
the adapter into the nearest wall outlet. The red power LED at
the front of the unit will illuminate, indicating the TView Silver is
ON.
