EN-18
Original User Guide | Groove Go Pedelec Version 2
*dependent on model
3.2.2 Adjusting the saddle height: Saddle clamp bolt(s)
*
1. Undo the saddle clamp bolt(s) by
turning it/them anticlockwise with an
Allen key.
2. Move the seatpost into the right
position.
3. Tighten the saddle clamp bolt(s) again
by turning it/them clockwise
10.
Torque settings Page EN-51
.
4. Test the tightness of the saddle by
trying to move it.
For 1. Loosen the saddle clamp bolt(s).
For 3. Tighten the saddle clamp bolt(s).
3.2
Adjusting the saddle height
3.2.1 Determining the correct saddle height
1. Sit on the pedelec and at the same time
lean against a wall.
2. Turn the pedal crank on the side away from
the wall to its lowest point.
3. Place your heel on the pedal.
Your leg should be fully extended.
4. If your leg is not fully extended when your heel is on the pedal, raise
the saddle. Lower the saddle if you cannot reach the pedal. The
following sections explain how to adjust the saddle height on your
bike. The seatpost can be fastened using the saddle clamp bolt
3.2.2 Adjusting the saddle height: Saddle clamp bolt(s)* Page EN-18
or
quick-release skewer
3.2.3 Adjusting the saddle height: Quick-release
skewer* Page EN-19
.
WARNING
Seatpost marking
The seatpost is marked to indicate how far you
may pull it out from the frame. Never pull the
seatpost further out than the marking. This could
cause it to bend or break, and cause you to fall.
For 3. Extend leg
