Operating Manual CMGZ 622
30
fig. 17: Program flow for special function „Adjust pilot control“
C611008e
Note
The additional analog input can only be operated in one mode at a time. When
changing parameter
Reference source, Pilot control
or
Taper function
, the
adjustment of pilot control is lost! If one of these parameters are changed after pilot
control already being adjusted, you have to proceed again for adjustment of pilot
control!
Partition the output into pilot control signal and PID output signal
•
Set parameter
Influence of PID
to an appropriate value, for ex. „50%“
•
Proceed for a test run. Adjust PID control parameters and parameter
Influence
of PID
until the control loop will run stable under all conditions.
